
XRNT-12 HV Current-limiting Fuse
12 kV current-limiting high-voltage fuse for transformer protection, used in series with the load break switch on the transformer HV side.

12 kV current-limiting high-voltage fuse for transformer protection, used in series with the load break switch on the transformer HV side.
An HV fuse protects the transformer on its high-voltage side; the fuse must coordinate with the cable and transformer withstand.
This item is specified against the single-line diagram and the site conditions; the common models and the parameter table below are the working reference, not a catalogue selection.
IEC Standard for MV Switchgear — what this item does
Role of the HV components
High-voltage components perform switching, protection, measurement and indication. The load switch carries normal current, the current-limiting fuse clears transformer faults, the surge arrester clamps overvoltage, and CT/PT supply metering and protection signals. Each is selected against the system voltage and short-circuit level.
Coordination matters as much as the part
A component only protects the installation if its rating is coordinated with the rest of the feeder — fuse curves with cable and transformer withstand, arrester rating with system earthing, and CT accuracy class with the relay. Always check the type-test report and the applicable IEC 62271 / IEC 60099 / IEC 61869 part for the exact model.
Common models
XRNT-12/6.3, XRNT-12/10, XRNT-12/16, XRNP-12 (PT protection fuse)
Typical parameters
| Parameter | Typical value | Basis |
|---|---|---|
| Electrical | ||
| Rated voltage | 12 kV | XRNT-12 model code |
| Rated current | 6.3 / 10 / 16 A | XRNT-12 model code |
| Rated breaking current | 31.5 – 50 kA, by class | GB/T 15166.2 |
| Fuse element | Current-limiting, silver-sand filled | Product design |
| Striker | Trip striker for switch-fuse interlock | Product design |
| Mechanical & environment | ||
| Mounting | Clip-in or bolt-in fuse holder, three-phase | Product variant |
| Ambient temperature | −25 to +40 °C | GB/T 15166.2 |
| Compliance & scope | ||
| Standards | GB/T 15166.2, IEC 60282-1 | Nameplate basis |
| Typical use | Transformer HV-side protection in RMUs and compact substations | Product scope |
Values are the working reference for this family and its standard models. On a project the rating, protection and cable schedule are confirmed against the single-line diagram and the site conditions before the quotation is issued.
Frequently asked questions
QWhat information is needed to specify this item?
Send the single-line diagram, rated voltage and current or capacity, short-circuit duty, installation environment, cable or terminal schedule, and any interface dimensions that apply to the item.
QAre the parameters on this page the final project values?
No. They are working reference values for the product family. The final model, rating, protection, accessories and scope are confirmed against the single-line diagram and site conditions before quotation.
QWhat is included in the quotation?
The quotation identifies the selected configuration, bill of materials, scope of supply and applicable test or document package. Loose accessories and site work are listed separately when applicable.
QCan the item be adapted to a project drawing?
Project-specific dimensions, interfaces and accessories can be reviewed against the drawings. Feasibility and the final configuration are confirmed for the selected model before production.
Need this quoted?
Send the single-line diagram and the site conditions. You get back a configuration, a bill of materials and a scope of supply — in writing, at quotation.