Automatic Transfer Switch (ATS)

Automatic Transfer Switch (ATS) — Package Substation
LV Components

Automatic Transfer Switch (ATS)

Auto transfer switch for dual-source supply switching; standard for important loads.

400 V100 – 250 A3P / 4PATS
Automatic Transfer Switch (ATS) — Package Substation

Auto transfer switch for dual-source supply switching; standard for important loads.

This item is specified against the single-line diagram and the site conditions; the common models and the parameter table below are the working reference, not a catalogue selection.

LV Switchgear Panel — what this item does

Role of the LV components

Low-voltage components handle incoming, distribution and protection on the 0.4 kV side: air and moulded-case circuit breakers, disconnectors, transfer switches, current transformers, meters and surge protective devices. Their ratings follow the load current and the fault level at the LV bus.

Selectivity and power quality

Breakers should be graded so a downstream fault trips only the nearest device. Add reactive-power compensation and harmonic treatment where the load demands it, and choose the SPD class to the site’s lightning exposure.

Common models

PC class (e.g. SQ30-100/4P), CB class (e.g. CDQ7-250/4P)

Typical parameters

ParameterTypical valueBasis
Electrical
Rated voltage400 VATS model code
Rated current100 – 250 A (SQ30-100 / CDQ7-250)Model code
Poles3P / 4PProduct variant
ClassPC class (load-break) or CB class (with protection)GB/T 14048.11
Transfer modeAutomatic, with manual emergency operationProduct design
ControllerVoltage-sensing controller, adjustable delayProduct design
Mechanical & environment
MountingFloor-standing cabinet or panelProduct variant
Ambient temperature−5 to +40 °CGB/T 14048.11
Compliance & scope
StandardsGB/T 14048.11, IEC 60947-6-1Nameplate basis
Typical useDual-source transfer between grid and generatorProduct scope

Values are the working reference for this family and its standard models. On a project the rating, protection and cable schedule are confirmed against the single-line diagram and the site conditions before the quotation is issued.

Frequently asked questions

QWhat information is needed to specify this item?
A

Send the single-line diagram, rated voltage and current or capacity, short-circuit duty, installation environment, cable or terminal schedule, and any interface dimensions that apply to the item.

QAre the parameters on this page the final project values?
A

No. They are working reference values for the product family. The final model, rating, protection, accessories and scope are confirmed against the single-line diagram and site conditions before quotation.

QWhat is included in the quotation?
A

The quotation identifies the selected configuration, bill of materials, scope of supply and applicable test or document package. Loose accessories and site work are listed separately when applicable.

QCan the item be adapted to a project drawing?
A

Project-specific dimensions, interfaces and accessories can be reviewed against the drawings. Feasibility and the final configuration are confirmed for the selected model before production.

Need this quoted?

Send the single-line diagram and the site conditions. You get back a configuration, a bill of materials and a scope of supply — in writing, at quotation.

Request a quotation
Package Substation

Specialized in package substations, switchgear cabinets and distribution components for global B2B projects. Configuration and bill of materials are fixed against the single-line diagram; assembly, wiring and routine test follow that drawing.

6 / 10 / 35 kV · 100–3150 kVA · IP54+

© 2026 Package Substation. All rights reserved.PrivacyContactmanager@packagesubstation.com
Scroll to Top